mlord wrote:
Quote:
Top photo looks correct (matches my own photo). Dunno about the bottom photo -- my memory is blank on that.



Loren,

Regarding the bottom photo, it doesn't matter which pin you use they are connected together on the board. It will be easiest to solder the free end of the 12v wire to a jumper then simply plug the jumper into those two pins.

As I indicated in a previous post, I'm not sure whether those pins supply regulated or unregulated 12v. You could try comparing the voltmeter reading here with the voltmeter reading across the outputs of the power supply brick while it is connected to the Empeg. In any case, I'd definately check with Benjammin that his circuit will be happy in the car with the 12v wire connected to these pins, before putting your Empeg back into your car.
_________________________
Michael
Ex-owner of stolen empeg #030102741