Quote:
Quote:
Did you get your fan to work?

Yeap. Looks that way so far =]

Quote:
did you see Benjamin's pictures? it looks like he is using a connector to the pcb board instead of soldering each wire to the board like you did.

I think that photo is of a prototype board. It doesn't look like the final board you can see in my photos.


Definitely a "proto" - when I did only one... I just hand wired it. At some point, I'll connect a new one in there to replace the original.

Quote:

Quote:
How will you mount the board?

3M double sided tap to the back of the case.



I used a dab of hot melt.

Quote:

Quote:
How did you solder to the scl and sda on the empeg board? is it okay to just solder at either end of each?

I just added a bit of solder to the resistors on the board, then reheated it with the iron and attached the wire.



That's how to do it.. use a LOW WATTAGE IRON. And be quick with the connections. Use enough heat, but I don't stick around more than 3 seconds or so...